sinograver >> FAQS >> YAG laser marking machine adjustment method

YAG laser marking machine adjustment method

YAG laser marking machine adjustment method
 Many on the market today YAG laser marking machine, and today we brought in Jinan Xin-day laser technician for you on what this model the optical path adjustment method:
 Optical path of adjustment to be patient, careful, detailed, concrete steps are as follows:

 If the laser when there are more than ten amps of current laser, but laser power is weak, then little can be adjusted according to the following method:

 A laser power sleep state to cancel, turn off the Q drive power.

 B and then check the laser beam with a frequency of quality films, if the laser when in a dark current of 14A, then carefully adjust the frames before and after reflection on the four knobs to become the brightest spot diameter, most garden.

 C and gradually adjust the output current of a small laser power until 10A, continue to carefully adjust the frames before and after reflection on the four knobs to become the brightest spot diameter, most garden. Optical adjustment is complete.

 Note: Do not be a knob too much, too fast, or else there is no case of the laser marking machine . Frames before and after the reflection is not to tighten the hex screw on the sudden release, it will be very prone to the case without the laser.

 Our equipment locking device in the light path adjusting optical path immediately after the lock, so the optical path is not correct.